Remote access tab – HP Power Distribution Unit Management Module User Manual
Page 41
HP PDR Management Module web interface 41
Remote Access tab
This screen enables administrators to enter information for remote access to the management module.
To configure remote access:
1.
Configure web access by doing one of the following:
o
Select Disable to disable web access.
o
Select Enable for HTTP Port and enter the port number to use HTTP.
o
Select Enable for HTTPS Port and enter the port number to use HTTPS.
o
Upload the SSL certificate:
i.
Open the SSL certificate file with a text editor.
ii.
Select all content.
iii.
Copy the selected content.
iv.
Paste the copied text to the SSL Key field.
NOTE:
If you enable HTTPS, the management module also uses the HTTP port to pass non-
sensitive information. Be sure that both ports are open.
2.
Configure telnet access by doing one of the following:
o
Select Disable to disable telnet access.
o
Select Enable for Telnet Port and enter the port number to use telnet.
3.
Configure the session management settings.
a.
(optional) Enable automatic signout and enter the number of minutes the management module
should wait before terminating an inactive session.
b.
(optional) Enable retries allowed, enter the number of times a user can unsuccessfully log in to
the management module before the account is locked, and enter the number of minutes to wait
between an unsuccessful login and a new login attempt.
4.
Enable FTP file upload to allow firmware and configuration upgrades.