HP Photosmart C4270 All-in-One Printer - Manual (Page 121)

The printout is blank
Cause: The original is placed incorrectly on the glass.
Solution: Load the original print side down on the right front corner of the glass as
shown below.
Cause: The print cartridges need to be cleaned or might be out of ink.
Solution: Check the estimated ink levels remaining in the print cartridges. If the
print cartridges are low or out of ink, you might need to replace the print cartridges.
If there is ink remaining in the print cartridges, but you are still noticing a problem,
print a self-test report to determine if there is a problem with the print cartridges. If the
self-test report shows a problem, clean the print cartridges. If the problem persists,
you might need to replace the print cartridges.
For more information on print cartridges, see
“Troubleshoot print cartridges”
on page 83 .
A borderless copy has white space around the edges
Cause: You are trying to make a borderless copy of a very small original.
Solution: When you make a borderless copy of a very small original, the HP All-in-
One enlarges the original up to a maximum percentage. This might leave white space
around the edges. (The maximum percentage varies by model.)
Depending on the size of the borderless copy you are trying to make, the minimum
size of the original varies. For example, you cannot enlarge a passport photo to create
a letter-size borderless copy.
If you want to make a borderless copy of a very small original, scan the original into
the computer, resize the image, and then print a borderless copy of the enlarged
image.
Cause: You are trying to make a borderless copy without using photo paper.
Chapter 13
118 Troubleshooting
T
roub
les
hoot
ing