HP Officejet 6210v All-in-One Printer - Manual (Page 155)

HP Quick Exchange Service (Japan)
HP Quick Exchange Service
0570-000511
:03-3335 -9800
: 9:00 5:00
10:00 5:00
1 1 3
:
Prepare your HP all-in-one for shipment
If after contacting HP Customer Support or returning to the point of purchase, you are requested
to send your HP all-in-one in for service, remove the print cartridges and pack the HP all-in-one
in the original packing materials to avoid further damage. You can remove print cartridges from
your HP all-in-one whether it is turning on or not. Retain the power cord and control panel
overlay in case the HP all-in-one needs to be replaced.
Note This information does not apply to customers in Japan. For information on service options
in Japan, see HP Quick Exchange Service (Japan) .
1 Turn on the HP all-in-one. If your HP all-in-one will not turn on, skip this step and go to step
2.
2 Open the print-carriage access door.
3 Wait until the print carriage is idle and silent, and then remove the print cartridges from their
slots. For information on removing the print cartridges, see
Replace the print cartridges .
Note If your HP all-in-one does not turn on, you can unplug the power cord and then
manually slide the print carriage to the far right to remove the print cartridges. When
finished, manually move the print carriage to the home position (on the left side).
4 Place the print cartridges in print cartridge protectors or an airtight plastic container so they
will not dry out, and put them aside. Do not send them with the HP all-in-one unless the
HP customer support call agent instructs you to.
5 Close the print-carriage access door and wait a few minutes for the print carriage to move
back to its home position (on the left side).
Chapter 16
152 HP Officejet 6200 series all-in-one