Enter text using the keypad on the control panel, Print reports, Generate reports automatically – HP Officejet 6210v All-in-One Printer User Manual
Page 89: Reports, see
You can also enter symbols from the keypad when you dial a fax or phone number.
When the HP all-in-one dials the number, it will interpret the symbol and respond
accordingly. For example, if you enter a dash in the fax number, the HP all-in-one will
pause before dialing the remainder of the number. A pause is useful if you need to
access an outside line before dialing the fax number.
Enter text using the keypad on the control panel
You can enter text or symbols by using the keypad on the control panel.
●
Press the keypad numbers that correspond to the letters of a name. For example,
the letters a, b, and c correspond to the number 2, as shown on the button below.
●
Press a button multiple times to see the available characters.
Note
Depending on your language and country/region setting, additional
characters might be available.
●
After the correct letter appears, wait for the cursor to advance automatically to the
right, or press . Press the number that corresponds to the next letter in the
name. Press the button multiple times until the correct letter appears. The first
letter of a word is automatically set to uppercase.
●
To insert a space, press
Space (#)
.
●
To enter a pause, press
Redial/Pause
. A dash appears in the number sequence.
●
To enter a symbol, such as @, press the
Symbols (*)
button repeatedly to scroll
through the list of available symbols: asterisk (
*
), dash (
-
), ampersand (
&
), period
(
.
), slash (
/
), parentheses
( )
, apostrophe (
'
), equals (
=
), number sign (
#
), at (
@
),
underscore (
_
), plus (
+
), exclamation (
!
), semi colon (
;
), question (
?
), comma (
,
),
colon (
:
), percent (
%
), and approximation (
~
).
●
If you make a mistake, press to clear it, and then make the correct entry.
●
After you are done entering text, press
OK
to store your entry.
Print reports
You can set up your HP all-in-one to print error reports and confirmation reports
automatically for each fax you send and receive. You can also manually print system
reports as you need them; these reports provide useful system information about your
HP all-in-one.
By default, your HP all-in-one is set to print a report only if there is a problem with
sending or receiving a fax. A confirmation message that indicates whether a fax was
successfully sent appears briefly on the control panel display after each transaction.
Generate reports automatically
You can configure your HP all-in-one so that it automatically prints error and
confirmation reports.
Chapter 11
86
HP Officejet 6200 series all-in-one