HP ProLiant DL580 G3 Server - Manual (Page 133)

Server software and configuration utilities 133
Erase Utility
CAUTION: Perform a backup before running the System Erase
Utility. The utility sets the system to its original factory state, deletes the
current hardware configuration information, including array setup and
disk partitioning, and erases all connected hard drives completely. Refer
to the instructions for using this utility.
Run the Erase Utility if you need to erase the system for the following reasons:
• You want to install a new operating system on a server with an existing
operating system.
• You want to change the operating system selection.
• You encounter a failure-causing error during the SmartStart installation.
• You encounter an error when completing the steps of a factory-installed
operating system installation.
The Erase Utility can be accessed from the Software and Drivers Download
website (
http://www.hp.com/go/support ) or the Maintenance Utilities menu of
the SmartStart CD ("SmartStart software" on page 123 ).
StorageWorks library and tape tools
HP StorageWorks L&TT provides functionality for firmware downloads,
verification of device operation, maintenance procedures, failure analysis,
corrective service actions, and some utility functions. It also provides seamless
integration with HP hardware support by generating and emailing support tickets
that deliver a snapshot of the storage system.
For more information, and to download the utility, refer to the StorageWorks
L&TT website (
http://h18006.www1.hp.com/products/storageworks/ltt ).
HP Systems Insight Manager
HP SIM is a web-based application that allows system administrators to
accomplish normal administrative tasks from any remote location, using a web
browser. HP SIM provides device management capabilities that consolidate and
integrate management data from HP and third-party devices.