HP ProLiant DL580 G3 Server User Manual
Page 67
Hardware options installation
67
1.
Power down the server ("Powering down the server" on page
2.
Remove all hard drives ("Removing a hot-plug SCSI hard drive" on page
and hard drive blanks ("Removing a hard drive blank" on page
3.
Extend the server from the rack ("Extending the server from the rack" on
page
4.
Remove the access panel ("Removing the access panel" on page
5.
Install the SAS controller. Refer to the directions provided with the controller
for installation instructions.
6.
Route and connect the power cable to the power cable connector on the SCSI
backplane.
CAUTION: When routing cables, always be sure that the cables
are not in a position where they can be pinched or crimped.
7.
Route the SAS cables through the opening near the SCSI backplane and over
the center wall.
8.
Connect the cables to the connectors on the back of the SAS hard drive cage.