HP TopTools for Hubs and Switches - Manual (Page 182)

14-2
Setting Up Security for a Device
Device Passwords
Figure 14-1. Device Passwords Page
There are two categories of passwords:
■ Operator (Read only)—The Operator can view all pages except the Secu-
rity pages. For switches, this password is the same as the console pass-
word.
■ Manager (Full Read and Write permissions)—The Manager can view all
pages and make any changes in any page. The Manager name and pass-
word are the same as the name and password used in accessing the device
through the console or a telnet session. If you change the password in this
page, the console password is overwritten and becomes this password.
Enter the desired names and passwords. The minimum recommended setup
is to have one Manager password. Click on the
Apply Changes button. If you
want to clear these changes select the Clear Changes button. This will not clear
any changes that you have already applied to the device.
Manager/Operator Password Combinations
The level of protection and the access granted to the device depends on what
passwords are set at what levels. The table below describes the settings and
their consequences.