HP TopTools for Hubs and Switches - Manual (Page 33)

3
System Requirements
Hardware and Software Requirements
HP TopTools for Hubs & Switches runs on Windows NT and Windows 2000.
The system requirements are listed in the following table.
Table 3-1. System Requirements
Item Requirements
Computer System IBM PC-compatible computer, 266 MHz processor; 400
MHz or higher recommended
Minimum RAM 128 Mbytes; 192 Mbytes or higher recommended
Free Disk Space 175 Mbytes
Note: At least 400 MB is needed to install all the required
Microsoft components on a computer that has only the
Windows NT operating system installed.
Paging File Size 150 MB
Disk Drive CD-ROM drive
Hardware Video Monitor and Interface
Card SVGA (32,768 colors minimum)
LAN Adapter Any LAN adapter supported by the system
Other A mouse or other pointing device that is supported by the
system
Note: Dual-homed or multi-homed PCs are not supported.
DHCP clients are supported. The IP address of the management station cannot be static or dynamic DHCP.
Software Supported Management
Platforms TopTools
HP OpenView Network Node Manager
Browsers Microsoft Internet Explorer (MSIE) 5.0 with Task
Scheduler, supplied on the TopTools CD-ROM
Operating System Microsoft® Windows NT version 4.0 with Service Pack 6a
(workstation or server) or Windows 2000
Web Server Windows NT 4.0 Options Pack from Microsoft