AltiGen comm 600H - Manual (Page 24)

Alti-IP 600H Manual 14
• IMPORTANT! When updating the Alti-IP 600H phone’s
firmware, it is recommended that administrators perform any
updates after normal business hours or when the IP phone is not in
use. If the Alti-IP 600H phone is in use during an update, the call
will be disconnected.
• The Apply To button works with the following parameters:
General, H.323, TFTP (Server field only; Reset IP Phone and
Boot Download options cannot be applied to multiple extensions),
and Debug. This only works when the Alti-IP 600H is operating in
basic mode.
• When setting up Alti-IP 600H connections, you must connect the
Alti-IP 600H to the network and to a power source before using it.
• When the Alti-IP 600H is booted up without the PC port plugged
in, the PC port defaults to 10Mbps.
• If the PC port is to be used, the user should plug in both the LAN
port and PC port before the IP phone is booted.
• The user should reboot the Alti-IP 600H under any of the following
conditions:
— after disconnecting the LAN cable to the phone
— after changing the IP address or DHCP setting
— after rebooting the PC
To connect the Alti-IP 600H:
a. Connect an Ethernet cable from the IP-PBX to the network port on
the phone.
b. Connect the handset to the receiver jack.
c. Connect an Ethernet cable from another network device, such as a
desktop computer, to the access PC port on the phone.
d. Connect the power plug to the AC Adapter port.
3. Configuring Startup Network Settings
If you are using DHCP, you do not need to configure anything.
Proceed to Step 5.
If you are not using DHCP, you must configure these network settings
on the Alti-IP 600H after installing the phone on the network:
• Local IP address