AltiGen comm 600H - Manual (Page 35)

Alti-IP 600H Manual 25
Modifying DHCP Settings
Dynamic Host Configuration Protocol (DHCP) automatically assigns IP
addresses to devices when they are connected to the network.
Enabling DHCP
The Alti-IP 600H automatically enables DHCP by default, but you can
reset the protocol if it becomes disabled using the following steps:
1. Press * * 7 + ENTER button.
2. Use / to select Network, then press the Enter key.
3. Scroll to Enable DHCP.
If DHCP is disabled, the option displays as DHCP Enabled NO.
4. Press (DOWN key) to enable DHCP.
Local
Address Network>Local
Address Sets the IP phone’s local address;
only shows if DHCP is disabled.
Network
Mask Network>Network
Mask Sets the IP phone’s network mask;
only shows if DHCP is disabled.
Gateway Network>Gateway Sets the Gateway IP address.
Enable
Gatekeeper Network>Enable/
Disable
GateKeeper Set whether GateKeeper is enabled or
disabled.
GateKeeper
Discovery Network>GK
Discovery Set to YES or NO to indicate whether
GateKeeper discovery is enabled. IP
Phone will automatically find
GateKeeper.
Enable NAT Network>Enable/
Disable NAT Set whether NAT is enabled or
disabled.
NAT Address Network>NAT
Address Sets the NAT server’s public IP
address.