AltiGen comm 600H - Manual (Page 39)

Alti-IP 600H Manual 29
Configuring NAT
NAT (Network Address Translation) is the translation of an IP address
used within one network to a different IP address known within another
network. One network is designated as the inside network, the other is the
outside. The Alti-IP 600H can be enabled to support H.323 behind NAT.
The Alti-IP 600H will be able to work behind a regular NAT router without
any special implementation for H.323.
For more detailed information regarding NAT configuration guidelines and
implementation, refer to the AltiWare OE/ACC or ACM System
Administration Manual.
Note: If more than one Alti-IP 600H phone sits behind NAT, a VPN
tunnel is required to connect between the NAT router and the
corporate router.
Assigning NAT
By default, NAT is not enabled. If you connect the Alti-IP 600H behind a
NAT router, you may manually assign the NAT router’s public IP address
to this field.
To assign the NAT address, use the following steps:
1. Press * * 7 + ENTER button.
2. Use / to select Network, then press the ENTER button.
3. Scroll to Enable NAT.
4. Press (DOWN key) to select YES.
5. Press the ENTER button.
6. Use (BACK key) to return to the Network menu, then select NAT
Address.
Use the buttons on the dial pad to enter the new NAT address, using
the * key to enter periods. Use (BACK key) to correct any mistakes.
7. Press the ENTER button.
Setting Ring Tones
The Alti-IP 600H Phone has three (3) ringing tones available. To set the
ring tone: