GE P2B940DEFWW - Manual (Page 28)

28
49-85212-4
Maintenance
CARE AND CLE
ANING:
Maintenance
SHOCK OR BURN HAZARD: %HIRUHUHSODFLQJRYHQOLJKWEXOEGLVFRQQHFWWKHHOHFWULFDO
power to the oven at the main fuse or circuit breaker panel. Failure to do so may result in
electric shock or burn.
WARNING
BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot
glass with bare hands or a damp cloth can cause burns.
CAUTION
Oven Light Replacement
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
%HIRUHUHSODFLQJWKHEXOEGLVFRQQHFWHOHFWULFDOSRZHUWR
the oven at the main fuse or circuit breaker panel. Let
the bulb cool completely before removing it. For your
safety do not touch a hot bulb with a damp cloth. If you
do the bulb may break.
To Remove:
7XUQWKHJODVVFRYHUFRXQWHUFORFNZLVHWXUQXQWLOWKH
tabs of the glass cover clear the grooves of the socket.
Remove the bulb.
To Replace:
3XWLQDQHZZDWWDSSOLDQFHEXOE3ODFHWKHWDEVRI
the glass cover into the grooves of the socket. Turn the
JODVVFRYHUFORFNZLVHWXUQ
NOTE:
Ŷ $ZDWWDSSOLDQFH
bulb is smaller than
DVWDQGDUGZDWW
household bulb.
Ŷ 5HFRQQHFWHOHFWULFDO
power to the oven once
the new bulb is installed.
Ŷ )RULPSURYHGOLJKWLQJ
inside the oven,
clean the glass cover
frequently using a wet
cloth. This should be
done when the oven is
completely cool.
Bulb
Socket
Tab
3 1 ø 2
”
Max
length
Glass cover
Lift-Off Oven Door
7KHGRRULVYHU\KHDY\%HFDUHIXOZKHQUHPRYLQJDQGOLIWLQJWKHGRRU'RQRWOLIWGRRUE\WKHKDQGOH
To Remove the Door:
 )XOO\RSHQWKHGRRU
 3XOOWKHKLQJHORFNVXSDQGDZD\IURPWKHUDQJH
frame to the unlocked position.
 )LUPO\JUDVSERWKVLGHVRIWKHGRRUQHDUWKHWRS
4. Close door until the top of the door is approximately
´IURPWKHUDQJHIUDPH
 /LIWGRRUXSDQGDZD\IURPWKHUDQJHXQWLOERWKKLQJH
arms are clear of the slots in the range frame.
To Replace the Door:
 )LUPO\JUDVSERWKVLGHVRIWKHGRRUQHDUWKHWRS
 :LWKWKHGRRUDWWKHVDPHDQJOHDVWKHUHPRYDO
position, rest the notch on the underside of the left
hinge arm on the bottom edge of the left hinge slot.
The notch in the hinge arm must be fully seated into
the bottom of the slot. Repeat for the right side.
 )XOO\RSHQWKHGRRU,IWKHGRRUZLOOQRWIXOO\ RSHQWKH
notches in the bottoms of the hinge arms have not
seated correctly in the bottom edge of the slot. Lift the
door off the range and repeat previous step.
4. Push the hinge locks toward the range cavity and
down to the locked position.
 &ORVHWKHRYHQGRRU
Removal position Pull hinge locks up to unlock
Push hinge locks down to lock Rest notch on bottom edge
of hinge slot
Notch
Bottom
edge of
slot
Hinge arm