GE PV970NSS - Manual (Page 6)

6
49-80549-2
Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood.
Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call our
WROOIUHHQXPEHU
National Parts Center
800.626.2002
GEApplianceParts.com
Stainless Steel Surfaces
Light Bulbs
CAUTION:
Allow bulbs to cool before touching .
To change the light bulbs:
1. Remove the lamp lens cover by inserting a
small flat blade screwdriver into each of the
three slots and gently prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Wear gloves. Do not touch the bulb with
your bare fingers. Skin oils can cause early
lamp failure.
3. Grasp the bulb and pull it straight out.
4. Replace with the same wattage. Early bulb
failure and damage to or failure of the
transformer may occur if wattage is too high.
These 12-volt, 20-watt halogen bulbs with
a G4 base are available at specialty lighting
stores and home building centers.
To order replacement bulb no. WB01X10239,
contact the GE National Parts Center at
1.800.626.2002 or purchase from your local
retailer.
5. Replace lamp lens cover by inserting the
three retaining tabs into the three slots and
pressing firmly in place.
Use a small flat blade screwdriver
to remove the lamp lens cover.
Outer trim ring
(lamp assembly)
Do not remove
Bulb
Removable inner
lamp lens cover
NOTE: Make sure the tabs are inserted into the
slots.
Tab