GE JVM3160DFWW - Manual (Page 14)

Installation Instructions
14
ADJUST BLOWER MOTOR A3
Remove the screws holding the blower unit and
the screws securing the blower plate. Remove
the blower plate from the outer case by sliding it
toward the back of the microwave and pulling up.
1
Blower Plate
Blower Motor Screws
Blower
Motor
Screw
2 Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
$'-867%/2:(502725 FRQW
A3
Roll the blower so that fan blade openings are
facing the top of the oven. Place the blower back
into the opening.
Slide the blower plate back onto the microwave
by placing the side tabs into the slots and pushing
gently until the back tab is seated into the rear slot.
Replace 3 screws.
Note: Make sure the wires remain routed through the
openings in the motor frame. To avoid damage to
the fan motor wiring, insert motor carefully such that
the fan motor wiring does not contact the microwave
power cord bracket.
3
4
Back of
Mircrowave
Rotate 90°
WARNING:
5LVNRI(OHFWULF6KRFN
Can cause injury or death. Do not pull or stretch the
EORZHUXQLWZLULQJ0DNHVXUHWKHZLUHVDUHQRW
pinched.
Side Tab
Side Slot
Rear Slot
Rear Tab
Back of
Mircrowave
Fan Blades
Wires