GE JVM3160DFWW - Manual (Page 16)

16
Installation Instructions
A5 MOUNT THE MICROWAVE OVEN
FRQW
Popcor n Conve nience Cook ing
Expre ss Coo k
Potato
Start
Pause Cance l Off
Bever age
Rehea t
Set Clock
Turntabl e Surfac e Light Vent
Add 30 Sec .
Power Level 0 8 5 2
7 4
1
9 6 3
Cook
Time Defro st Weigh t/Time Timer
On/Of f
5
4 Tighten the three screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Install grease filters. See the Owner’s Manual
packed with the microwave oven.
Insert 3 self-aligning screws ( 1 ø 4 s-28 x 2 1 ø 4
”) through
outer top cabinet holes. Turn two full turns on each
screw.
3
Cabinet Front
Cabinet Bottom Shelf
Filler Block
Microwave Oven Top
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
Self-Aligning Screws
This distance
can NOT
exceed 2”
to ensure
proper
installation
,167$//,1*5(3/$&,1*7+(
CHARCOAL FILTER WITHOUT
ACCESS TO TOP SCREWS AND THE
UNIT HAS ALREADY BEEN MOUNTED
A6
DISMOUNT THE MICROWAVE OVEN
CAUTION:
7RDYRLGWKHULVNRISHUVRQDO
LQMXU\ EDFNLQMXU\RURWKHULQMXULHVGXHWRH[FHVVLYH
ZHLJKWRIWKHPLFURZDYH RUSURSHUW\GDPDJH\RXZLOO
QHHGWZRSHRSOHWRXQLQVWDOOWKLVPLFURZDYH
IMPORTANT: Do not grip or use handle during removal.
WARNING:
5LVNRI(OHFWULF6KRFN&DQ
FDXVHLQMXU\RUGHDWK ,IUHPRYLQJXQLWZLWKPHWDO
FRXQWHUWRSVFRYHUWKHHGJHRIWKHSRZHUVXSSO\FRUG
KROHZLWKWKHSRZHUVXSSO\FRUG Q\ORQJURPPHW 
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
Popco rn Conve nience Cook ing
Expre ss Coo k
Potato
Start
Pause Cance l Off
Beverag e
Rehea t
Set Clock
Turntabl e Surfac e Light Vent
Add 30 Sec .
Power Level 0 8 5 2
7 4 1
9 6 3
Cook
Time Defro st Weigh t/Time Timer
On/Of f
Popcorn Convenience Cooking
Express Cook Potato
Start Pause Cancel Off
Beverage Reheat
Set Clock
Turntable Surface Light Vent
Add 30 Sec.
Power Level 0 8 5 2 7 4 1
9 6 3
Cook Time Defrost Weight/Time Timer On/Off
Loosen the 3 screws on the top of the microwave
oven (inside the cabinet).
1
Lift microwave, tilt it forward and unhook slots at
back bottom edge from the four lower tabs of the
mounting plate.
2
Replace the filter using instructions from section A4.
Reinstall unit following instructions from A5.
3
4