GE JGAS02SENSS - Manual (Page 32)

32
Installation Instructions
INSTALL THE ANTI-TIP DEVICE
Mark the wall where the RIGHT EDGE
of the range is to be located. Be sure
to allow for the countertop overhang
if you intend to install the range next
to cabinets.
Locate the outside edge of the device
2 1 ⁄
8
″ toward the center of the range from
the marked edge of the range.
Using the device as a template, mark the
position of the hole for the screw.
C
B
A
12
WARNING
—
• Range must be secured with an
approved Anti-Tip device.
• Unless properly installed, the range could
be tipped by you or a child standing,
sitting or leaning on an open door.
• After installing the Anti-Tip device, verify
that it is in place by carefully attempting
to tilt the range forward.
• This range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
Anti-Tip
device
Slotted head
screw
Approx. 20°
2 1 ⁄
8
″
Wallplate
Marked edge
of range
LEVEL THE RANGE
For proper cooking and baking, the
range must be leveled. Leveling legs are
located on each corner at the base of the
range.
Install the oven shelves (see use and
care section for instructions). Put a
spirit level or a glass measuring cup
partially filled with water on one of
the oven shelves.
Turn the legs counterclockwise to
raise the range and counterclockwise
to lower the range. Adjust the
leveling legs until the range is level.
After the range is level, slide the
range away from the wall so that the
Anti-Tip device can be installed. C
B
A
11