Design information, Product dimensions – GE ZVC42LSS User Manual

Page 8

Advertising
background image

8

Design Information

PRODUCT DIMENSIONS

A 1/2" wide flange surrounds the outside edge of

the insert sleeve.

Remote Location for the Control
The control may be removed from the hood
and installed into a wall or countertop. A 30-ft.
length of wire is supplied to accommodate most
installations. A blanking plate covers the opening
when the controls are removed.
The overall size of the control is 4-1/4" wide and
2-1/4" deep.

We recommend that the cutout in granite or other
hard surfaces be made before the countertop is
installed.

The stainless steel liner is shipped with each hood
insert. This non-combustible liner protects the
underside of the canopy.

Custom Liner
If you are not using the supplied liner, you may
construct a custom non-combustible liner. Use the
supplied liner as a template. The opening must be
38-3/4"W x 13-3/16"D.
3/4"thick material must

surround the opening to allow the sleeve locking
clips to engage. The insert sleeve inside the cabinet
should be positioned 1/2" from the rear wall so
that the center of the 8" duct is 5-1/2" from the
rear wall.

*Opening

ZVC48

The custom canopy must be sized to fit the insert

sleeve. Construct the canopy with an opening

that is:

38-3/4"W x 13-3/16"D

The opening must be constructed of 3/4" thick
material to allow the sleeve locking clips to
engage.

The Supplied Liner

Dimensions and Specifications (in inches)
Outside Dimensions

The Insert Sleeve

1-11/16"

3-11/16"

Control cutout

14"

39-1/2"

Front side

4"

46-1/2"

21-1/4"

1/2"

3-7/8"

7-1/2"

38-1/2"

13"

14"

29-1/2"

1/2"

1/2"

13"

1/2"

Front side

Advertising
This manual is related to the following products: