GE 45605 GE Z-Wave Duplex Receptacle User Manual
Page 16
Advertising
LED Light
When shipped from the factory, the LED on the 45605 is
set to turn ON when the connected outlet is turned OFF.
To make the LED turn ON when the light is turned ON,
change parameter 3’s value to “1”
.
- Parameter No: 3
- Length: 1 Byte
- Valid Values = 0 or 1 (default 0)
Restoring Factory Defaults
All network settings and configuration parameters can all
be restored to their factory default settings by using your
master controller to reset the device. (delete it from network)
Over-Current Protection
Over-current protection is provided by an internal fuse
which is not user serviceable. Check your home’s circuit
breakers before concluding that the product must be
replaced.
Advertising