GE 45605 GE Z-Wave Duplex Receptacle - Manual (Page 14)

Manual Control
The Pushbutton on the 45605 receptacle allows the user to:
Manually turn the connected equipment ON or OFF by
pressing the button.
- This is a toggle switch; if the device is OFF, pressing the button
turns the device ON and vice versa.
2. Include or exclude the receptacle from the Z-Wave home
control network with your primary controller.
- Refer to the instructions for your primary controller to access the
network setup function and include or exclude devices.
- When prompted by your primary controller, tap the button.
- The primary controller should indicate that the action
was successful. If the controller indicates the action was
unsuccessful, please repeat the procedure.
- Once the module is part of the network, the same basic
procedure is used to add the module to groups or scenes. Refer
to the primary controller’s instructions for details.
Please Note: After a power failure, the 45605’s Z-Wave controlled
receptacle returns to its last used ON/OFF state.
LED Indicator
- The LED will be lit when the Z-Wave controlled outlet is OFF.
- This is the factory default setting and can be changed if your
primary controller supports the node configuration function (see
Advanced Operation below).
1.