Ag Leader InSight Spinner Spreader - Manual

Part No. 2002831-39 Rev. D 1
Granular Spinner Spreader Module
Quick Reference Sheet
Section 1: Configuration Procedure
The following procedure describes the complete process of configuring a granular
spinner bed control system. To begin, go to the Application Setup Configuration Tab,
press the Add button, and the Operating Configuration Wizard appears.
Note: In order for you to use this configuration at the Run screen, you must
configure a vehicle, implement, controller and product(s). For more information on how
to configure these, consult the InSight User Manual.
Granular Spinner Spreader Configuration
STEPS ACTION
1 Select Equipment Configuration Type
Note: This step will only be present if the Multi-product feature has been
unlocked in the display. Skip ahead to Step 2 if you have not purchased a
Multi-product unlock code.
Select Single Product Application from the drop-down list, then press Next
to continue.
2 Select Vehicle
Use the drop-down list to select an existing vehicle from the Vehicle list, or
press New to launch the Vehicle Wizard to create a new vehicle.
Note: If you do not need to create a new vehicle, skip ahead to Select
Operating Mode in Step 7 on page 2.
3 Create New Vehicle
If you pressed New, the Vehicle Setup Wizard appears.
Self-Propelled Spreader operators should select Self-Propelled
Spreader from the Vehicle Type list box. Select Spinner from the
Spreader Type list box; then press Next to continue.
Other operators should select another vehicle type under the Vehicle
Type list.
4 Enter Vehicle Information
Use the on-screen keyboard to enter names for the Vehicle Make and Model.
Press Next to continue.