Ag Leader InSight Seed Command Clutch Control - Manual

1
Clutch Control
Quick Reference Guide
2006001-ENG Rev A
Using the settings (in the table to the left) should produce good
field results However, always take the time to check for proper seed
placement in the field and make system setting adjustments as needed.
Do not rely solely upon the appearance of the On-Screen map. The on
screen map will not show gaps and overlaps caused by incorrect GPS
Offsets or AutoSwath Look-Ahead settings.
How far ahead of time (in seconds) the system must
disengage the clutch before exiting a planted area.
Note: this value is in seconds. For best performance, do not
change travel speed as you are exiting the planted area, wait
until clutch sections have turned off
Start of Configuration Wizard Planting
To create a configuration, make the following button presses to start the Configuration
Wizard and then follow the instructions given on the display.
Enter Settings
Press to Highlight Configuration
8360,1770,3dr
Planting
Configuration Product
Minimize Skip - The entire clutch section
rectangle (shown to the right) must pass
into non planted area before the section
will cease planting.
Minimize Overlap - The clutch section
will cease planting when any portion of
the section rectangle passes into a non
planted area.
User Defined - This option is configurable
from 1-100%. This is the amount of the
section rectangle that must pass into a non
planted area before the section ceases
planting.
Keep Unchanged - Clutch section on/off
status will not change when exiting the field
as defined by the outside boundary.
Turn Section Off - Clutch section will cease
planting when exiting the field as defined by
the outside boundary.
Planter Unit Seed
Meter Type
On/Off Electric
Clutch
Air
Clutch
Finger Units
Turn On 0.9 1.1
Turn Off 0.3 0.3
Vacuum
Turn On 0.9 1.1
Turn Off 0.4 0.4
This option determines how far ahead of time (in seconds)
the system must engage the clutch before entering a planted
area. Note: this value is in seconds. For best performance,
do not change travel speed as you are nearing the planted
area. Accelerate either well before entering the planted area,
or after all clutch sections have turned on.