American Fibertek SM10p-PoE - Manual (Page 38)

Spanning Tree Commands Set
Commands Level Description Example
spanning-tree enable G Enable spanning tree switch(config)#spanning-tree
enable
spanning-tree priority G Configure spanning switch(config)#spanning-tree
[0~61440]
spanning-tree max-age
tree priority parameter priority 32767
G Use the spanning-tree switch(config)#spanning-tree
[seconds] max-age global
configuration
command to change
the interval between
messages the
max-age 15
spanning-tree
spanning tree receives
from the root switch. If
a switch does not
receive a bridge
protocol data unit
(BPDU) message from
the root switch within
this interval, it
recomputed the
Spanning Tree
Protocol (STP)
topology.
G Use the spanning-tree switch(config)#spanning-tree
hello-time [seconds] hello-time global
configuration
command to specify
the interval between
hello bridge protocol
data units (BPDUs).
hello-time 3
spanning-tree G Use the spanning-tree switch(config)#spanning-tree
31