Displaying spvc details – ADC AVIDIA SWD4573I1 User Manual
Page 219
Chapter 8: Configuring ATM Virtual Circuits
Avidia System Configuration and Management User Manual
193
Displaying SPVC Details
From the appropriate
::spvc=>
prompt, type the detailshow command in the following
format, then press
.
detailshow <slot.port> <vpi> <vci>
Parameters
<slot.port>
The slot and port for which you want to display SPVC information (format slot.port).
Omitting this parameter displays all configured SPVC information for the system.
<vpi>
The specific VPI for which you want to display all configured SPVC information. Omitting
this parameter displays SPVC information for all VPIs.
<vci>
The specific VCI for which you want to display all configured SPVC information. Omitting
this parameter displays SPVC information for all VCIs.
Example
::spvc=>detailshow 3.2 100 100
A screen similar to the following displays:
ENTER
::spvc=>detailshow
Admin Status:
Up
Operation Status:
In Progress
Source Slot:
3.2
Source VPI
100
Source VCI
100
Destination Address:
39:26:34:34:75:85:11:08
Source Tx Traffic Index:0
Source Rx Traffic Index:0
Last release cause:
0
Retry Failures:
0
Retry Interval:
10
Retry Limit:
0