EOTech ATPIAL (AN/PEQ-15) - ADVANCED TARGET POINTER ILLUMINATOR AIMING LIGHT - Manual (Page 40)

2-18
2.8 MODE SELECTION (Continued)
Safety Screw
WARNING
The safety screw shall be installed in the lockout
position when the ATPIAL is in storage, being
returned to the armory, or distributed to field
personnel.
A removable safety screw installed in the lockout position
prevents the Mode Selector from being turned to the high
power laser settings (i.e., AH, IH, DH). A 3/32” hex head
wrench is used to remove the safety screw when, for tactical
reasons, access to the high power laser settings is desired
(see section 3.3, Replacing Safety Screw). The safety screw
storage location allows for secure storage of the safety
screw after it has been removed from the lockout position.
Figure 2-11. Safety Screw Shown Lockout Position.
SAFETY SCREW
LOCKOUT POSITION
SAFETY SCREW
STORAGE LOCATION