ididit Retrofit Steering Column: 1970-74 Cuda/Challenger Ignition Switch - Manual

ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
Instruction #: 8000020005 REV 07/09
www.ididitinc.com
Chrysler E-Body Wires
(Included with E-Body Kit)
Part Numbers: 1620810010, 1620810020, 1620810051, 1620820010, 1620820020, 1620820051,
Figure 1 is for the turn signal switch. It plugs in
between the turn signal switch and the dash harness.
Note: One end is pointed, this will only go one way.
Figure 2 is for the ignition system. This plugs in
between the relay pack and the dash harness. Please
notice that the Red and Black wires have the same style
connector. It is critical that you joint the two Red wires
together, and then the Black to Brown together.
Figure 3 is also for the ignition and has 3 relays built
into it. This relay harness has one four wire plug that
goes to the column. One lone black wire that need’s
a good ground location. Then the three smaller plugs,
these plug into the
Figure 2 plug as described above.
These relays have mounting tabs if you choose to mount
them or they can hang, it is not necessary to ground the
tabs.
Note: If you are not using an OEM harness there is a
breakdown of these wires by function in the Retrofit
Steering Column Installation Instructions.