ididit Steering Wheel Adaptor: 9-Bolt Shorty Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
“Shorty” Adaptor Instructions
For Part Number’s 2201100020, 2201100040
Instruction #: 8000010002 REV 01/13
Caution ~ Watch for clearance: Turn signal lever may have
to be straightened or flipped over for clearance of fingers
between wheel & lever. There may also be a chance you will
have clearance issues between your adaptor and shift lever.
If this is the case give us a call we may have a solution.
1. Remove your old steering wheel and horn assembly
while saving the nut that held on your steering wheel.
2. Disassemble the “Shorty” Adaptor. (Figure 1)
3. If using an original GM column remove the dust cover
(if equipped). If the dust cover is steel remove the 3
screws. If the dust cover is plastic, pry it off. Discard
the cover it will no longer be required.
4. Make sure the male piece of the horn cam is at 10:30.
This ensures that the turn signals will cancel properly
once your installation is complete.
(Figure 2 A.)
5. With your adaptor in hand, install the attached horn wire
into the horn cam. Place the wire and spring in the male
end of the horn cam. Then push and turn the plastic
sleeve of the horn wire 1/8th of a turn clockwise to fit in
the locking groove.
(Figure 3 A.)
6. Slide the bottom piece of the adaptor onto the splined
shaft protruding from steering column. (Figure 4 B.)
When you do this the horn cam and horn wire should go
through the horn wire hole on the adaptor.
(Figure 4 A.)
Replace the nut and tighten.
7. Wheel thickness may vary from one wheel manufacturer
to another. Included with your adaptor are two sets of
screws (short and long). We strongly recommend using
the longer screws first, if they reach the bottom of the
hole before securing the wheel to the adaptor then the
shorter screws should be used.
8. Install the steering wheel and the 9 bolts that hold
the wheel on. Remember to have the steering wheel
straight.
(Figure 5)
9. Insert the spring into the backside of the horn button and
slide it over the center shaft of the column. (Figure 6 A.)
10. While holding the horn button install the top piece of the
adaptor by sliding it over the horn button and aligning
the 3 holes.
(Figure 7) Install the 3 screws and your
installation is complete! (Figure 8)