ididit Steering Wheel Adaptor: Basic Adaptor - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Steering Wheel Adaptor Installation Instructions
For Part Number’s 2201009920-2201059951, 2201300020-2201320051, 2202009920-2202340051,
2202709920-2202709940 & 2207310020-2207320040
Instruction #: 8000010001 REV 03/14
1. Remove the old steering wheel, nut and horn assembly.
2. If using an original GM column remove the dust
cover (if equipped). If the dust cover is metal remove
the 3 screws. If the dust cover is plastic, pry it off.
Discard the cover, it will no longer be needed.
3. Make sure the male piece of the horn cam is at
10:30. (Figure 2 A.) This ensures that the turn
signals will cancel properly once your installation
is complete.
4. Install the ididit adaptor by aligning the horn cam
hole and center the splined shaft protruding from
the steering column. (Figure 3 B.) Replace the nut
and tighten to approximately 35ft. lbs. (Figure 4)
Occasionally because of the minimum clearance, the
adaptor will rub on your column. If this is the case
with your column, simply remove the adaptor and
wrap one turn of clear cellophane tape on the tapered
area of the steering column just below the splined
area. Sometimes it is necessary to wrap the tape area
twice.
5. Install your steering wheel to your new adaptor.
Remember to have the steering wheel straight.
6. Install the horn wire (wire may be attached to inside of
horn button). The horn wire fits through the adaptor
into the horn cam. (Figure 5) Turn 1/8th of a turn,
clockwise. Push the other end of the wire into the
spade protruding from the back of the horn button.
(Figure 6) Push the horn button on an angle into the
adaptor. (Figure 7)
7. Your installation is now complete! (Figure 8)
The following instructions can be used for any ididit 5, 6 or 9-Bolt Steering Wheel Adaptor (A 9-Bolt Adaptor is pictured in these instructions)