ididit Golf Cart Steering Column: Club Car - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Club Car Golf Cart Instructions (1992-2004)
For Part Number’s 1129200120, 1129200020
Instruction #: 8000000050 REV 12/12
Step 1
Step 5
Step 2
Step 6
Step 3
Step 7
Step 4
Step 8
Step 1 - Remove the front cowl.
Step 2 - Remove the upper u-joint bolt. The new ididit column will use the original u-joint.
Step 3 - Loosen the four lower column support bolts and remove the old column.
Step 4 - Loosen the dash and tilt it forward to allow for greater clearance for the wiring on the new
ididit column.
Step 5 - Slide the column into the lower column support. The wires should exit the column at the 12
o’clock position.
Step 6 - Attach the original u-joint to the column. Be sure to retighten the u-joint block and the column
support bolts.
Step 7 - Install the knobs and levers that were provided with the Dress-up Kit.
Step 8 - Use a 9-bolt ididit steering wheel adaptor to bolt your favorite aftermarket steering wheel to
you new ididit Golf Cart Column. Please note: The top shaft is the same size as a 1969 or
newer GM passenger car.