JELD-WEN JII027 Wood Patio Doors without Exterior Trim or Nailing Fin - Manual (Page 4)

INSTALLATION INSTRUCTIONS
for Wood Patio Doors without Exterior Trim or Nailing Fin (JII027)
4
Note! Do not allow gaps or bubbles beneath the flashing (remove and
replace if necessary).
c. Remove the
upper end
corner of each
side piece, and
for step-down
landings,
remove the
lower end
corner.
d. Apply the
side pieces of
self-adhesive
flashing.
e. Remove the
corners of the
header piece
and apply.
3. Apply sealant across
flashing/masonry
joints at corners of
masonry opening.
4. Apply diamond
lath to all flashed
surfaces to be
covered by stucco.
END of Buck Instructions, SKIP to section 7, “PREPARE PATIO DOOR.”
Note! This section covers installations into a buck only. For, stud-framed
wall installations skip to section 6, “PREPARE STUD-FRAMED WALL.”
1. On the exterior,
coat the buck
and surrounding
concrete/masonry
with self-
adhesive flashing
primer. Follow
manufacturer’s
instructions
for application
procedures.
2. Seal the joint
between the buck
and the concrete/
masonry with
JELD-WEN self-
adhesive flashing as
follows:
a. Cut four pieces
of self-adhesive
flashing for the
sill, sides and
head as shown.
b. Apply the sill
pan piece of
self-adhesive
flashing over
the sill pan
as shown. The bottom of the sill pan should be sealed by the
flashing.
2. Mark a line across
the front and back
of the sill pan.
3. Apply three 3/8"
beads of sealant
between the lines.
4. Place the sill pan in
the rough opening.
Firmly press the sill
pan into the sealant
with a J-roller.
If installing into
masonry:
1. Cut a piece of self-
adhesive flashing
the length of the
sill.
2. Cut a notch out of
each end and apply
to the sill as shown.
Both installations:
1. Set the sill pan
in the rough
opening, aligning
the front edge (for
continuous slab,) or
folded down edge
(for step down) with the exterior edge of the rough opening.
4
5
INSTALL SILL PAN
PREPARE BUCK
Sealant
Top
= Remove for step down only
3"
1.5"
Rough opening side jamb +3"
Rough opening head/sill +3"
1.5"
3"
Head/Sill piece
Side piece
Side piece
Sealant
Diamond lath
(if applicable)