JELD-WEN JII027 Wood Patio Doors without Exterior Trim or Nailing Fin - Manual (Page 8)

INSTALLATION INSTRUCTIONS
for Wood Patio Doors without Exterior Trim or Nailing Fin (JII027)
8
COMPLETE INSTALLATION - CONTINUED
9
Please visit jeld-wen.com for finishing instructions, warranty and care
and maintenance information.
Thank you for choosing
COMPLETE INSTALLATION
• On the exterior of
step down landings,
install support trim
underneath the sill
where it extends past
the landing. Position
trim snugly against the
bottom of the sill toe.
• Adjust patio door for
best operation.
• Create a continuous
air seal on the interior
between the rough
opening and the frame
with low expansion
foam or backer rod
and sealant.
Gap
Backer
rod
Gap
Sealant
joint
AFTER INSTALLATION
• Install exterior wall surface within seven days of installation.
• Maintain gap of 1/4"-3/8" between door frame and final exterior wall
surface (siding, stucco, etc.).
• Seal this gap on the sides with backer rod and sealant. For step-down
landings, also seal under the patio door sill with a discontinuous joint.
Do not apply sealant on top of the drip cap.
• Seal any gaps or openings at end of horizontal mull joints with
sealant.
• Remove protective film (if applicable) on glass within one year and
immediately from cladding.
• Protect recently installed units from damage from plaster, paint, etc.
by covering the unit with plastic.
• Finish all exposed wood surfaces immediately following installation.
©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual property laws.
All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others. Unauthorized use or duplication
of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
(05/14)