JELD-WEN JII027 Wood Patio Doors without Exterior Trim or Nailing Fin User Manual
Page 7
INSTALLATION INSTRUCTIONS
for Wood Patio Doors without Exterior Trim or Nailing Fin (JII027)
7
ADJUST LOCK
1. Loosen the lock
hook screws in the
side jamb so it can
be moved up or
down.
2. Insert the alignment
guide into one of
the openings in the
faceplate.
3. Carefully close the
panel and raise
or lower the lock
hook until it aligns
with the slots in the
faceplate. Tighten the screws.
4. To lock the door, rotate the thumb turn 90°.
ADJUST SLIDING DOOR PANEL ROLLERS
Note!
Adjust the panel high enough to avoid drag. Keep door panel
parallel to the jamb by almost closing the door and looking for an even
reveal/gap.
Remove both door roller adjustment plugs on the interior bottom
of the operating panel. Using a flat head screwdriver, turn the screw
counterclockwise to raise the panel or clockwise to lower it.
INSTALL EXTERIOR TRIM
For wood exterior
doors not assembled
with brickmold casing,
attach the pre-cut
brickmold 9/16" from
the interior frame edge
to the sides and head
with 2 1/2" casing nails.
Seal brickmold to frame
with silicone sealant
and tool into a fillet
joint.
1. On the exterior,
apply backer
rod and sealant
between the frame
head/side jambs and
the rough opening.
2. Release the
building wrap from
above the header
(previously taped
up) and overlap
the drip cap. Seal
the ends with self-
adhesive flashing or
building wrap tape.
3. Apply a 1/4" bead
of sealant around
the sill where it
meets the slab or
step. Leave 1" gaps
at weep holes as
shown.
4. Ensure sealant on
back dam of the sill
pan fully seals to
the inside face of
the sill. Apply more sealant as necessary.
5. Install lockset hardware per supplied instructions.
6. Some French double door units may require installing lock bolts at
the top and bottom of the inactive panel. Locate the center point of
each lock bolt, drill 3/8" bolt holes and install keeper plates.
COMPLETE INSTALLATION
9
Backer rod
and sealant
1"
Lock
hook
Faceplate
Alignment
guide
Frame
Panel
Brickmould
9/16"
gap