Sper Scientific 840052 Data Acquisition Software - Manual (Page 18)

16
The screen shows T1 temperature value in the left block and T2
temperature is shown in the right block.
The meter unit can be easily changed the unit at your disposal,
o o If the meter is set in C, the data logging will show in C. Once you
o o change the meter unit to F, the screen unit will be changed to F
simultaneouly. Recommend to reset the Display range at the
same time, or you will see a minor chart change on the screen.
(See Diagram T)
K.J.T. TYPE & K.J.T.R.S.E.
DUAL INPUT THERMOMETER
FORMAT:
Baud Rate :2,400 bit /sec.
Data Bits : 8
Stop Bit : 1
TXXX.XC(F):TXXX.XC(F)
Diagram T