Sper Scientific 840099 Datalogging Manometer - Manual (Page 12)

12
MEASUREMENT PROCEDURES
Run Auto Logger
0023: 06-30. 02:28:55
P: 0.1 psi
0024:
P:
0025:
P:
P-PG N-PG BACK
Begin: 30-06-06
Start: 02:28:06
End: 02-07-05
Suspend: 03:28:55
Rate: 60Sec(s)
Expect: 12000Point(s)
Remain: 11977Point(s)
START CLR BACK
Welcome
MEAS MEM LOG SET
EXIT START SET NEXT
06-30 02:28:55
0.1 psi 0023:
P:
0024:
P:
0025:
P:
Logging. . .
STOP MEAS VIEW
Begin: 30-06-06
Start: 02:28:06
End: 02-07-05
Suspend: 03:28:55
Rate: 60Sec(s)
Expect: 12000Point(s)
Remain: 11977Point(s)
EXIT EDIT VIEW NEXT
0023: 06-30 02:28:55
P: 0.100 psi
0024:
P:
0025:
P:
STOP MEAS ESC
P: 0.100 psi
ESC
1. Press F3 (LOG) to enter log
mode.
2. Press F3 (SET) to modify the us-
er-defined parameters.
3. Use the ▲ and  buttons to se-
lect an auto log parameter and
press F2 (EDIT) to edit.
“Begin” date*
“Start” time
“End” date*
“Rate” (1 to 7200 seconds)
“Suspend” time
 For 24 hour logging, set the Start
time to 00:00:00 and the Sus-
pend time to 23:59:59.
 “Expect” is the total number of
memory points (12,000).
 Remain” shows the number of
available memory points (12,000
minus the number already
recorded).
* Ensure date formats are consistent