Vaisala PTU200MIK1 - Manual (Page 11)

C HAPTER 3___________________________________________________ PTU200MIK1 INSTALLATION
V AISALA __________________________________________________________________________ 9
Probe installations
HMP45 series
HMP233 series
1. Push the HMP45 probe through the
plastic nut to the radiation shield as deep
as it goes. 2. Pull back about 10 mm.
3. Finally, tighten the plastic nut.
1. Attach the HMP233 probe to the support
with an upper cable tie.
2. Press the probe cable into the groove of
the support.
3. Fasten the lower cable tie.
4. Push the probe through the plastic nut
into the radiation shield as deep as it goes.
5. Finally, tighten the plastic nut.
Sensor head
support
Cable
tie
Plastic nut