Vaisala PTU200MIK1 - Manual (Page 12)

U SER ' S G UIDE _______________________________________________________________________
10 __________________________________________________________________ N OVEMBER 2001
HMP243 series
Sensor
head
support
Cable
tie
Plastic nut
1. Attach the HMP243 probe to the support
with an upper cable tie.
2. Press the probe cable into the groove of
the support.
3. Fasten the lower cable tie.
4. Push the probe through the plastic nut
into the radiation shield as deep as it goes.
5. Finally, tighten the plastic nut.