Red Lion LDSG - Manual (Page 5)

4.0 r
evIeWIng the
F
ront
B
uttons and
d
Isplay
DSP
PAR
F1
F1
RST
MIN
MAX
TOT
1 2
5
KEY DISPLAY MODE OPERATION PROGRAMMING MODE OPERATION
DSP Index display through max/min/total/input readouts* Quit programming and return to display mode
PAR Access parameter list Store selected parameter and index to next parameter
F1  Function key 1; hold for 3 seconds for Second Function 1** Increment selected parameter value
F2  Function key 2; hold for 3 seconds for Second Function 2** Decrement selected parameter value
RST Reset (Function key)** Hold with F1  , F2  to scroll value by x1000
* Display Readout Legends may be locked out in Factory Settings.
** Factory setting for the F1, F2, and RST keys is NO mode.
Parameters
Function
Secondary
4-SEC
Parameters
Input
1-INP
Pro
DISPLAY
MODE
Lock-out Key
2-FNC
Parameters
3-LOC
Parameters
Function Program
Communication (Alarm) (Integrator)
6-SPt 5-tOt 7-SrL
Parameters
Setpoint Totalizer Serial
Service
9-FCS
Factory
Parameters Parameters Operations
Signal
User Input/
NO
MAIN MENU PAR
F1/F2
Keys
Display/
PAR PAR PAR PAR PAR PAR PAR PAR
OVERVIEW
PROGRAMMING MENU
5.0 p
rograMMIng the
M
eter
DISPLAY MODE
The meter normally operates in the Display Mode. In this mode, the meter
displays can be viewed consecutively by pressing the DSP key. The annunciators
to the left of the display indicate which display is currently shown; Max Value
(MAX), Min Value (MIN), or Totalizer Value (TOT). Each of these displays can
be locked from view through programming. (See Module 3) The Input Display
Value is shown with no annunciator.
PROGRAMMING MODE
Two programming modes are available.
Full Programming Mode permits all parameters to be viewed and modified.
Upon entering this mode, the front panel keys change to Programming Mode
operations. This mode should not be entered while a process is running, since
the meter functions and User Input response may not operate properly while
in Full Programming Mode.
Quick Programming Mode permits only certain parameters to be viewed and/
or modified. When entering this mode, the front panel keys change to
Programming Mode operations, and all meter functions continue to operate
properly. Quick Programming Mode is configured in Module 3. The Display
Intensity Level “” parameter is available in the Quick Programming
Mode only when the security code is non-zero. For a description, see Module
9—Factory Service Operations. Throughout this document, Programming
Mode (without Quick in front) always refers to “Full” Programming Mode.
PROGRAMMING TIPS
The Programming Menu is organized into eight modules (See above). These
modules group together parameters that are related in function. It is recommended
to begin programming with Module 1 and proceed through each module in
sequence. If lost or confused while programming, press the DSP key to exit
programming mode and start over.
FACTORY SETTINGS
Factory Settings may be completely restored in Module 9. This is a good
starting point if encountering programming problems. Throughout the module
description sections which follow, the factory setting for each parameter is
shown below the parameter display.