8 module 8 - a, Out asin, Type an-lo an-hi udt – Red Lion PAXDP User Manual
Page 26: Nalog, Utput, Arameters
26
26
8-Out
ASIN
Analog
Type
tYPE
AN-LO
AN-HI
udt
Analog
Update Time
PAR
Analog
Assignment
Analog Low
Scale Value
Analog High
Scale Value
Pro
6.8 mOdule 8 - a
nalOg
O
uTpuT
p
arameTers
(
) Ñ
PARAMETER MENU
Enter the analog output type. For 0-20 mA or 4-20 mA
use terminals 18 and 19. For 0-10 V use terminals 16 and
17. Only one range can be used at a time.
ANALOG TYPE
ANALOG ASSIGNMENT
Enter the Display Value that corresponds to 0 mA (0-20
mA) , 4 mA (4-20 mA) or 0 VDC (0-10 VDC).
ANALOG LOW SCALE VALUE
ANALOG HIGH SCALE VALUE
ANALOG UPDATE TIME
to
to
to
Enter the source for the analog output to retransmit:
= Relative (net) Input Value. The Relative Input
Value is the Absolute Input Value that includes
the Display Offset Value.
= Absolute (gross) Input Value. The Absolute Input
Value is based on Module 1
and
entries.
= Calculation Value
= Totalizer Value
= Minimum Display Value
= Maximum Display Value
Enter the Display Value that corresponds to 20 mA (0-20
mA) , 20 mA (4-20 mA) or 10 VDC (0-10 VDC).
Enter the analog output update rate in seconds. A value
of 0.0 allows the meter to update the analog output at the
ADC Conversion Rate.
RANGE
0 to 20 mA
4 to 20 mA
0 to 10 V
SELECTION
Ñ
- An analog output card must be installed in order to access this
module.