Red Lion PAXDP - Manual (Page 8)

Sinking Logic
Terminal 9:
Terminal 10-11:
}
In this logic, the user inputs of the meter
are internally pulled up to +5 V with 22
K resistance. The input is active when it
is pulled low (<0 .9 V).
+
(30V max.) SUPPLY
V
USER
2
USER
1
USER COMM.
10 9
-
11
4.3 USER INPUT WIRING
Before connecting the wires, the User Input Logic Jumper should be verified for proper position. If not using User
Inputs, then skip this section. Only the appropriate User Input terminal has to be wired.
Sourcing Logic
Terminal 9: -VDC thru external switching device
Terminal 10-11: + VDC thru external switching device
In this logic, the user inputs of the meter are internally
pulled down to 0 V with 22 K resistance. The input is
active when a voltage greater than 3.6 VDC is applied.
USER
2
USER
1
USER COMM.
9 10 11
Connect external switching device between
appropriate User Input terminal and User Comm.
DSP
8.8.8.8.8
A
C
B
PAR F1 F2 RST
A
1 S P S P S 2 3 P P4 S
Display
Readout
Legends*
Optional Custom
Units Overlay
Setpoint Alarm
Annunciators
* Display Readout Legends may be locked out in Factory Settings.
** Factory setting for the F1, F2, and RST keys is NO mode.
RST
F2 
F1

PAR
DSP
KEY
Hold with F1  , F2  to scroll value by x1000 Reset (Function key)**
Decrement selected parameter value Function key 2; hold for 3 seconds for Second Function 2**
Increment selected parameter value Function key 1; hold for 3 seconds for Second Function 1**
Store selected parameter and index to next parameter Access parameter list
Quit programming and return to display mode
PROGRAMMING MODE OPERATION DISPLAY MODE OPERATION
5.0 r
evieWing The
f
rOnT
b
uTTOns and
d
isplay
8
Index display through main displays as programmed in 
4.4 SETPOINT (ALARMS) WIRING
4.5 SERIAL COMMUNICATION WIRING
4.6 ANALOG OUTPUT WIRING



See appropriate plug-in card bulletin for details.