Red Lion C48T - Manual (Page 37)

1. DISPLAY: 2 Line by 6 digit LCD display; Positive image reflective or negative
image transmissive with red (top line) and green (bottom line) backlighting.
Main Display: 0.3" (7.62 mm) high digits
Secondary Display: 0.2" (5.08 mm) high digits
Annunciators:
Value: PRS, 1, and 2
Output: 01 and 02
2. POWER REQUIREMENTS:
AC Versions (C48TXX0X):
AC Power: 85 to 250 VAC, 50/60 Hz, 9 VA max.
DC Power: 11 to 14 VDC @ 150 mA max. (Non PNP output models)
Note: AC Versions with PNP outputs cannot be powered from DC.
DC Versions (C48TXX1X):
CONTINUOUS:
DC Power: 18 to 36 VDC; 5.5 W max.
AC Power: 24 VAC
±10%; 50/60 Hz; 7 VA max.
Note: The +10% tolerance range on AC input voltage must be strictly
adhered to. DO NOT EXCEED 26.4 VAC.
PEAK (START-UP CURRENT):
AC or DC Power: 500 mA peak start-up current for 10 msec max.
3. MEMORY: Nonvolatile E 2 PROM retains all programmable parameters and
timer values.
4. SENSOR POWER: +12 VDC ( ± 15%) @ 100 mA max.
5. INPUTS: Run/Stop, User Input 1, User Input 2, and User Input 3.
Configurable as current sinking (active low) or current sourcing (active high)
inputs via a single plug jumper.
Current Sinking (active low): V
IL
= 1.5 VDC max, 22 K
Ω pull-up to
5 VDC.
Current Sourcing (active high): V
IH
= 3.5 VDC min., V
IN
max = 30 VDC;
22 K Ω pull-down.
Run/Stop Response Time: 250
µsec max.
User Input Response Time: 5 msec max.
6. TIME ACCURACY: ± 0.01%
7. OUTPUTS: (Output type and quantity, model dependent)
Solid-State:
NPN Open Collector: I
SNK
= 100 mA max. @ V
OL
= 1.1 VDC max;
V
OH
= 30 VDC max.
PNP Open Collector: I
SRC
= 100 mA max.(See note); V
SRC
= 12 VDC
±15% (using internal supply); V
SRC
= 13 to 30 VDC max. (using
external supply).
Note: The internal supply of the C48T can provide a total of 100 mA for
the combination of sensor current and PNP output sourcing current.
The supply voltage is +12 VDC (±15%), which will be the PNP output
voltage level when using only the internal supply.
If additional PNP output sourcing current or a higher output voltage
level is desired, an external DC supply may be connected between the
-31-
APPENDIX “B” - SPECIFICATIONS AND DIMENSIONS
DIMENSIONS In inches (mm)
PANEL CUT-OUT
C48t-im.QXD 3/5/04 3:29 PM Page 31