Introduction, Cautions, Warranty information – High Country Tek HFS-J-Bus User Manual
Page 4: Controller updates, Controller information
Electronic Controller Solutions for the Global Fluid Power Industry
Hydraulic Fan System Controller with SAE J1939 Interface
HFS-J User Guide
Part No:-
021-00158 Rev C
HFS-J Hydraulic Fan System Controller User Guide
Page | 4
Welcome
to the High Country Tek Inc. ( HCT ) HFS-J Hydraulic Fan Drive system controller user guide, and thank you
for selecting this HCT controller to use in your application.
The following information is designed to allow you to connect, set-up and optimize the HFS-J module. If you have
used HCT products before, you will recognize some of the instructions and settings. For those of you that are new to
HCT, please read the directions with care and be sure that if you have any questions regarding this industry unique
controller, then please contact us one of the numbers given on the back page of this manual.
We value our customers, their experience and abilities and ask that if you would like to see any additions,
subtractions or find any errors in this publication, that you contact HCT’s customer service so that we can correct the
information and make sure that our programming community is using the latest information.
If you require urgent support, more information or would like specific programming areas clarified, you can contact us
on the customer support number at 1 530 265 3236 or E-mail us through our website at
ving
details of your issue and how we can contact you.
Introduction:
This manual is designed to provide information needed for the installation and use of the HFS-J Hydraulic Fan System
Controller. Its intended user is qualified trained service personnel that understand the hazards involved in an
electromechanical environment. It is recommended that this manual be read in its entirety before installation is
begun with particular attention paid to caution and safety information.
Cautions:
Changing setup values and limits under computer control while the machine is operating may cause sudden machine
movement, which may lead to possible injury or death. It is strongly recommended that any moving parts are disabled
prior to any alignment procedure whenever possible. In any case, caution should be exercised during any procedure
and work should be completed only by qualified trained personnel.
Warranty Information:
High Country Tek Guarantees this product to be free of defects in materials and workmanship for a period of one year
extending from the date the unit was shipped from the factory. Within this time frame, High Country Tek will provide
evaluation of warranted items free of charge. Warranty repair or replacement will be at the factory’s discretion. If
necessary, contact the factory for return authorization by phone (530) 265-3236, Fax (530) 265-3275, E-Mail
or by writing our service department at, High Country Tek, Service Dept., 208 Gold Flat
Court, Nevada City, CA 95959. To help us serve you better, please have the units full Model / Part Number and Serial
Number available when contacting the factory for any reason. Do not return products to the factory without prior
authorization and a RMA number attached.
Controller Updates:
HCT continuously improve the controllers and make additional information and/or features available.
Please check on-line at
for the latest products, updated software and controller information.