High Country Tek HFS-J-Bus - Manual (Page 6)

Electronic Controller Solutions for the Global Fluid Power Industry
Hydraulic Fan System Controller with SAE J1939 Interface
HFS-J User Guide
Part No:- 021-00158 Rev C HFS-J Hydraulic Fan System Controller User Guide Page | 6
Product Overview
• NO software experience needed to apply this controller successfully.
• Pre-written ‘Fan Drive’ software for easy, fast system configuration, development and production.
• Intuitive Graphical User Interface ( GUI ) runs on any PC with Windows® XP or newer software ( .net compatible ).
• 9 to 32VDC operation with full reverse polarity and SAE J1455 protection.
• Extended -40ºC ( -40ºF ) to +85ºC ( +185ºF ) controller operational temperature range.
• CE approved to latest international test standards.
• J1939 CAN Bus communications for engine and temperature zone data Inputs
•
** J1939 temperature data hard coded for :
 Engine water/coolant at PGN 65262,
 Transmission Oil temperature at PGN 65272
 Intake manifold/charge air Temperature at PGN 65270
• All inputs and outputs protected from shorting to ground or the power supply.
• Diagnostic LED display shows I/O status and module operation at a glance.
• ‘Blinking’ error code LED for fast on-site ‘health check’.
• System wiring and coil fault detection and alarms.
• Alarm output for integration into host system.
• IP68 (NEMA 6P) rating on module for harsh environment reliability ( connector IP rating may differ ).
• Single Deutsch Metri-pack 150 series I/O 12 way connector for easy system wiring.
• Separate RS232 communications connector for programming, monitoring and diagnostics.
• Rugged encapsulated product withstands harsh environments found in mobile applications.
• Non Volatile Memory maintains ALL settings without power
• Completely user configurable for setting confidentiality.
• Compatible with all manufacturers fan system hydraulic valve and pump control products.
** J1939 Temperature Data NOTE:-
If the J1939 PGN data for temperature is NOT correct for a particular engine, HCT can change the PGN number
to one that is correct and re-issue the program code to you. Please use the contact numbers on the back page
of this manual to discuss this with our customer support personel.