Electrix Tweaker Editor Reference - Manual (Page 9)

3. Control Settings
9
3.4 LED Rings
The LED rings for the encoders can be controlled independently of the
encoder value. This is useful if you want to use the rings to display an
absolute value while the encoders are in relative mode.
cc#
Enter a CC number that you want to use to control the LED ring to send.
Valid CC numbers range from 0-119.
ch
Enter a MIDI channel that the control will send on. All controls can be
set to one of 16 possible channels.
mode
The mode menu determines how the LED ring responds to knob turns.
8 Walk: (default) illuminates only one LED at a time to indicate value.
8 Fill: Illuminates all LED’s that precede the current value, eventually lighting all LED’s at the
maximum value.
8 EQ: Fills to the left or right from top-center and is ideal for DJ EQ’s that have cut/boost values
from center.
8 Spread: Fills both sides from center. This is useful for parameters that indicate a “width”.
3.5 Drum Pads
The velocity (pressure) sensitive drum pads can be configured to send a note as well as a CC
aftertouch. Each pad can be set to its own channel.
note
Enter a note number that you want the drum pad to send. Valid note numbers range from 0-127.
ch
Enter a MIDI channel that the note will send on. All controls can be set to one of 16 possible channels.
cc#