Kenwood RA-5000 - Manual (Page 31)

English
31
Set
u
p
Speaker Distance Speaker Distance
Sets the distance between each speaker and the listening
position. The actual distances should be measured before starting
this setup.
Distances of speakers
Measure the distance from the listening position to each speaker
and jot down in the table below.
RV-7000
Speaker Input channel
Distance from the
listening position
Front speaker (left) "LEFT" meters (feet)
Front Height speaker (left) "LEFT HEIGHT" meters (feet)
Center speaker "CENTER" meters (feet)
Front Height speaker (right) "RIGHT HEIGHT" meters (feet)
Front speaker (right) "RIGHT" meters (feet)
Surround speaker (right) "SURR RIGHT" meters (feet)
Surround Back speaker (right) "SURR BACK RIGHT" meters (feet)
Surround Back speaker "SURR BACK" meters (feet)
Surround Back speaker (left) "SURR BACK LEFT" meters (feet)
Surround speaker (left) "SURR LEFT" meters (feet)
Subwoofer "SUBWOOFER" meters (feet)
RV-6000
Speaker Input channel
Distance from the
listening position
Front speaker (left) "LEFT" meters (feet)
Center speaker "CENTER" meters (feet)
Front speaker (right) "RIGHT" meters (feet)
Surround speaker (right) "SURR RIGHT" meters (feet)
Surround Back speaker (right) "SURR BACK RIGHT" meters (feet)
Surround Back speaker "SURR BACK" meters (feet)
Surround Back speaker (left) "SURR BACK LEFT" meters (feet)
Surround speaker (left) "SURR LEFT" meters (feet)
Subwoofer "SUBWOOFER" meters (feet)
RA-5000
Speaker Input channel
Distance from the
listening position
Front speaker (left) "LEFT" meters (feet)
Front speaker (right) "RIGHT" meters (feet)
Subwoofer "SUBWOOFER" meters (feet)
1
Select "DISTANCE".
[SETUP]
[MULTI CONTROL ∞/5]
[SETUP]
2
Set the distance.
Refer to the table above for the distance from each speaker
to this unit.
Adjustment starts from front left speaker.
Use [MULTI CONTROL ∞/5] to set the distance.
[SETUP]
The distance can be set in the range of 0.3 to 9.0 meters (1
to 30.0 ft) in 0.3-meter (1-feet) increments.
3
Repeat step 2 for each speaker until the distances
of all speakers are set.
4
Go to the next setting.
Crossover Crossover
The crossover frequency is the lower limit of the bass frequencies
reproduced from the speakers set to "NML" in the <Speaker
configuration>. The frequencies below the set crossover
frequency are output from other speakers (those set to "LRG" and
the subwoofer).
1
Select "CROSSOVER".
[SETUP]
[MULTI CONTROL ∞/5]
[SETUP]
2
Set the crossover frequency.
Use [MULTI CONTROL ∞/5] to select crossover frequency.
[SETUP]
The frequency is selected from 40, 60, 80, 100, 120, 150 and
200Hz.
3
Go to the next setting.
B60-5827-08_00_En.indd 31 10.8.3 11:08:03 AM