Kenwood RA-5000 - Manual (Page 41)

English
41
S
u
rrou
n
d ef
fe
c
ts
Surround play using the listen
mode
Select the listen mode according to the source being played back.
/,67(102'(
5959
/,67(102'(
Preparations
• Turn the components to be used ON.
• Complete <Speaker setup>.
• Select the source you wish to play back with
surround sound.
• Select the input mode fl.
(When the input mode is set to "AUTO" (i.e. when
the "AUTO DETECT" indicator is lit), the listen
mode matching the input signal type and speaker
setups is selected automatically. Noise may be
produced when a DTS source is played by selecting
the analog input.)
1
Start playing the selected source.
2
Use [LISTEN MODE] to select the listen mode.
Each press switches the listen mode.
• RA-5000 :
The listen mode can be selected when Dolby Virtual
Speaker is on (when the input is the 2ch signal).
L : Front Left speaker
LH : Front Height Left speaker
SW : Subwoofer
C : Center speaker
R : Front Right speaker
RH : Front Height Right speaker
SL : Surround Left speaker
SR : Surround Right speaker
SB : Surround Back speaker
SBL : Surround Back Left speaker
SBR : Surround Back Right speaker
RA-5000
2.1ch stereo system
L R SW
TV / SCREEN
Listen mode
Dolby Virtual Speaker Off
· Stereo
Dolby Virtual Speaker On
· Dolby Pro Logic II
(Movie, Music)
· Neo:6 (Cinema, Music)
• Certain listen modes cannot be selected depending on
the input signal.
B60-5827-08_00_En.indd 41 10.8.3 11:08:19 AM