Kenwood K-511USB-B - Manual (Page 12)

1 2 3
3
Adjusting the volume
Adjust using [VOLUME]
Decreasing the
volume level Increasing the
volume level
Increasing the
volume level
Decreasing the
volume level
Adjust in the range from 0 to 40 (max.).
Turning the knob quickly (on the main unit) or
holding a button depressed (on the remote control
unit) accelerates the volume variation speed.
•
Muting the audio temporarily
Press [MUTE].
"MUTE" blinks on the display.
To cancel muting
Press [MUTE] again (this resumes the original
volume) or adjust the volume.
■
2
3
22 K-511USB/RD-K511USB 23 English
1
Turn the system ON (OFF).
Press [ K].
Pressing the play/pause button of the desired audio
input source also turns the system ON. (page 17,
"One-touch operation function")
Pressing [ K] while the system is ON switches it OFF
(standby mode).
2
Set the source to be played.
How to load a CD
1Press [L] on the main unit to open the tray.
2Place a disc with the label side facing up.
3Press [L] on the main unit to close the tray.
" " is displayed.
How to connect a USB device
Hold the device in the correct orientation and
insert the connector all the way. "
" is
displayed.
To disconnect the USB device:
After stopping, set the system to the standby
mode and pull out the USB device.
•
•
■
How to load an SD card
Insert the card completely into the SD1 or SD2
slot. "
" or " " is displayed.
Be careful of
orientation.
Insert the SD card so that the label side faces up and
the side with a cut comes on the right.
To remove the SD card:
After stopping, set the system to the standby
mode and push the SD card. When it pops out,
grasp it and pull out.
To use a mini SD or micro SD card:
microSD card
adapter
microSD card
Attach the card to a special adapter (commercially
available) and insert it. The adapter is inserted in the
same orientation as the SD card.
3
Start playback.
Press the play/pause button of the desired audio
source.
[CD E], [USBE],
[SD1 E], [SD2E], [TUNER],
[iPod/D.AUDIO], [AUX]
Note on audio source switching
Since this system is compatible with various audio
sources (CD, SD card, USB device, etc.), the input
selection is not switched by simply setting the
audio source in the system.
In this manual, the operation of switching the input
selector is expressed as "audio source switching".
Whenever this instruction is given, press the play button
for the desired audio source. The switching operation
should sometimes be started from stop mode.
•
■
■
•
■
Basic Operation
This symbol indicates an operation on the main unit. When
it is marked, perform the operation by pressing the required
button(s) on the main unit.
This symbol indicates an operation on the remote control
unit. When it is marked, perform the operation by pressing the
required button(s) on the remote control unit.
When both are marked for an operation, it can be controlled either
on the main unit or the remote control unit.
Pla
ying music tracks