Kenwood K-511USB-B - Manual (Page 50)

98 K-511USB/RD-K511USB 99 English
Reproducing audio with sound
properties close to the original
(SPRM: Supreme)
When the played audio fi le lacks high frequencies
due to compression used in recording, this function
optimizes the reproduced audio using Kenwood-
original technology.
SPRM is valid in playback of SD1, SD2 and USB.
1
Select "SPRM".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
"SPRM" lights when "ON"
is selected.
2
Select ON/OFF.
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
With the remote control unit, this function can be set
with the CD, SD and USB audio sources.
To set using [SPRM] of the remote control unit
Press [SPRM].
Each press switches ON/OFF.
•
•
Playing best-fi t sound according
to genre (BestFit EQ EX)
This function reproduces the optimum sound
according to the genre of music.
1
Select "BestFit EQ EX".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
" " lights when ON is
selected.
2
Select one of the preset modes.
Press [MULTI CONTROL A/B].
Each press switches the selection.
OFF
Vocal High
Vocal Low
Radio mode
BestFit EQ EX is
canceled.
女性ボーカルの声を
明瞭に再生します。
男性ボーカルの声を
明瞭に再生します。
ラジオ放送のパーソナリ
ティーの声などを明瞭に再
生します。
3
Enter the selection.
Press [ENTER].
Pressing [FLAT] ends the BestFit EQ EX setting after
saving the last condition. Pressing [FLAT] again resets it
to the original setting.
BestFit EQ EXを設定するとMANUAL EQが解除
されます。
To set using [BEST FIT EQ EX] of the remote control unit:
Press [BEST FIT EQ EX].
Each press switches the preset mode.
•
•
2
Adjust the balance position.
Press [MULTI CONTROL C/D].
3
Enter the selection.
Press [ENTER].
Resetting the adjusted
frequency characteristics to the
original sound (FLAT)
All of the adjustments set with D-BASS, TONE,
MANUAL EQ, SPRM and BestFit EQ EX can be reset
to the fl at condition to reproduce the original
sound as it is.
1
Press [FLAT].
Press [FLAT].
Each press switches ON/OFF.
When ON is selected,
lighted indicators such as
"TONE" and "D-BASS" are
turned off .
If the D-BASS, TONE, MANUAL EQ, SPRM and BestFit EQ EX
settings are not adjusted after FLAT is set to ON, pressing
FLAT again to OFF recalls their previous settings.
• Cr
eating the desir
ed sound setting
Making the sound setup using the Setup menu
Playback with high sound
quality
(HR SOUND)
This is Kenwood-original sound quality
improvement technology, which is capable of
reproducing the CD audio with lower distortion as
well as audio fi les.
HR SOUND以外の音質設定がOFFのときに有効で
す。
1
Select "HR SOUND".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
"SPRM" lights when "ON"
is selected.
2
Select ON/OFF.
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
Setting the left and right
speaker balance (BALANCE)
Adjust the balance of volume between the left and
right speakers.
1
Select "BALANCE".
Press [MULTI CONTROL A/B]
to select, then press [ENTER].
•