Kenwood NX-300SE - Manual (Page 32)

21
‡ (QWHUD)OHHWQXPEHUWRPDNHDFDOOWRDOOXQLWVLQWKHVHOHFWHG
ÁHHW )OHHWFDOO 
‡ (QWHUDQ,'QXPEHUWRPDNHDFDOOWRWKHVHOHFWHG,'LQDOO
ÁHHWV 6XSHUYLVRUFDOO 
• Select “ALL” Fleet and “ALL” ID to make a call to all units
%URDGFDVWFDOO 
STATUS MESSAGE
<RXFDQVHQGDQGUHFHLYHGLJLW6WDWXVPHVVDJHVZKLFKPD\
be decided in your talk group. Messages can contain up to 16
DOSKDQXPHULFFKDUDFWHUV6WDWXVPHVVDJHVUDQJHIURPWR
 a DUHUHVHUYHGIRUVSHFLDOPHVVDJHV 
$PD[LPXPRIUHFHLYHGPHVVDJHV FRPELQHGVWDWXV
PHVVDJHVDQGVKRUWPHVVDJHV FDQEHVWRUHGLQWKHVWDFN
memory of your transceiver.
Q Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
PRGH SURFHHGWRVWHS RUSelcall + Status to enter
6HOFDOOPRGH SURFHHGWRVWHS 
3 Press  WRVHOHFWWKHVWDWLRQ\RXZDQWWRFDOO
• If Manual Dialing is enabled, you can enter a station ID
by using the DTMF keypad, or by using
 . When
using  , cycle through the digits to select a digit,
then press to set the digit and move the cursor to the
right. Repeat this process until the entire ID is entered.
4 Press to enter Status mode.
5 Press  WRVHOHFWWKHVWDWXV\RXZDQWWRWUDQVPLW
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using
  UHIHUWR
VWHSDERYH 
6 Press the PTT VZLWFKRUSide 2 key to initiate the call.
‡ ´ &203/(7(!µDSSHDUVRQWKHGLVSOD\ZKHQWKHVWDWXV
has been successfully transmitted.