Kenwood TK-2180E - Manual (Page 49)

42
■ A
UTO
R
EPLY
M
ESSAGE
You can set the transceiver to automatically respond to
Individual Calls (while using FleetSync):
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
• The Auto Reply Message indicator ( )
appears on the display.
2 When you receive an Individual Call, Auto Reply will
begin after waiting for 3 seconds, the transceiver will
send an automatic response to the caller, and
“
” appears on the display.
• If you are available to receive the call, press any key to
disable the auto response.
• If memory is available on your transceiver for recording, "I
am not available. Leave your Message." will be sent to
the caller. The caller can then leave a recorded message
on your transceiver which you can later recall and listen
to. When a message is stored on your transceiver,
"
" appears on the display.
• If no memory is available on your transceiver for
recording, "I am not available." will be sent to the caller
and “
” appears on the display.