Kenwood KDC-BT40U - Manual (Page 23)

English | 23
Selecting the Bluetooth Device You
Wish to Connect
When 2 or more Bluetooth devices have already
been registered, you need to select the Bluetooth
device you wish to use.
1 Select Bluetooth device selection mode
For how to select setup item, refer to <Bluetooth
Setup> (page 20).
Select “SETTINGS”
> “PHONE SELECT” (“PHONE
SEL”).
2 Enter Bluetooth device selection mode
Press the [VOL] knob.
“(name)” is displayed.
3 Select the Bluetooth device
Turn the [VOL] knob.
4 Set up the Bluetooth device
Press the [VOL] knob.
‘
✱(name)’ or ‘-(name)’ is displayed.
“ ✱”: The selected Bluetooth device is busy.
“-”: The selected Bluetooth device is on standby.
“ “ (blank): The Bluetooth device is deselected.
5 Exit Function Setting mode
Press the [ ] button for at least 1 second.
⁄
• If a cell-phone is already selected, deselect it, and then
select a different one.
Downloading the SMS
Download the short message (SMS) arrived at the
cell-phone so that it can be read on this unit.
1 Select SMS download mode
For how to select setup item, refer to <Bluetooth
Setup> (page 20).
Select “SETTINGS”
> “SMS DOWNLOAD” (“SMS
DL”).
2 Enter SMS download mode
Press the [VOL] knob.
“DOWNLOADING” is displayed.
When the downloading finishes, “COMPLETE” is
displayed.
3 Exit Function Setting mode
Press the [ ] button for at least 1 second.
⁄
• The cell-phone must be able to transmit the SMS using
Bluetooth. Setting on the cell-phone may be required.
If the cell-phone does not support SMS function, the
SMS download item in Function Control mode is not
displayed.
• When the SMS is downloaded from the cell-phone, the
unopened messages in the cell-phone are opened.
$AA'A'PINKUJKPFF