Kenwood KDC-BT40U - Manual (Page 33)

English | 33
STEERING WHEEL
REMOTE INPUT
MUTE
ANT. CONT
P.CONT
REMOTE CONT
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
L R
Connecting Wires to Terminals
USB connector
AUX input (Stereo)
Use the mini-plug cable which is
stereo type and does not have any
resistance.
Battery wire (Yellow)
Ignition wire (Red)
FM/AM antenna input (JASO)
Antenna Cord
Wiring harness (Accessory1)
If no connections are made, do not let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Mute control wire (Brown)
Connect either to the power control terminal when using
the optional power amplifier, or to the antenna control
terminal in the vehicle.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
See next page
Fuse (10A)
To use the steering wheel remote control feature, you
need to an exclusive remote adapter (not supplied)
matches your car is required.
Steering remote control (Light Blue/Yellow)
To connect the Kenwood navigation system, consult your
navigation manual.
KDC-BT40U KDC-BT30
Rear output/Sub Woofer output
Switches the preout between rear output (“REAR”) and subwoofer
output (“SUB-W”). Refer to “SWITCH PREOUT”/(“SWITCH PRE” ) of
<Initial Setting> (page 18).
$AA'A'PINKUJKPFF